![]() However, some operating systems can control the operation with hardware drivers. Support for this feature is implemented on the motherboard (in the BIOS) along with the network interface or firmware. Remote Wake-Up is independent of the operating system, or network interface card (NIC), used by the computer. ![]() The Remote Wake-Up feature goes by many names, including: wake on LAN (WOL), wake on WAN, wake up on LAN, power On By LAN, power Up By LAN, resume by LAN and resume on LAN.įor computers communicating via WiFi, the wake on wireless LAN” (WoWLAN) supplementary standard must be used. However, there are exceptions making it possible to remotely wake-up a computer from outside its LAN. Generally, Remote Wake-Up will only work if magic packets are sent from a computer on the same local area network (LAN) or within the current network subnet. This feature is included in Intel’s Wired for Management (WfM) network specification. The computer receiving the magic packet does not need to be left “on,” as was the case before Remote Wake-Up became available so IP personnel no longer have to manually turn “on” networked computers, or remind employees to do so, before remotely checking, configuring, installing software or other tasks. On receipt, the computer initiates the system wake-up. Remote Wake-Up refers to remotely turning on a networked computer by sending a network message (called a magic packet) that contains the MAC address of the computer.
0 Comments
Leave a Reply. |